Contour Enthusiasts Group CEG

Modifications >> Duratec Maintenance

Hard-core CEG'er

Reged: 05/25/04
Posts: 3637
Loc: Calgary, Alberta, Canada
Pulling Rotor
#1312198 - 09/04/06 08:15 PM

Well it seems my rotor is going to be a huge PITA to get off. I went ahead and got a gear puller that will probably wourk with the rotors (it fits up and everything) its 3 teird and im HOPING it dosent warp it at all.

Now i need to know if its safe to put the middle part (the one tong that works the opposite way) pushing into the axle.. where the axle nut usually is. Can i put any pressure on that, or is it bad for the axle??

99 TRed Contour SVT # 1853 out of 2760
230.2 WHP @ 6500
237.0 WTR @ 2250

Originally posted by MxRacer:
Originally posted by RawBurt:
I'll be keeping it to myself, until the time comes. It'll be hard to find.

much like your weiner.

Post Extras Print Post Remind Me! Notify Moderator

Entire thread
Subject Posted by Posted on
* Pulling Rotor Tourige 09/04/06 08:15 PM
. * Re: Pulling Rotor Big Jim 09/05/06 03:38 AM
. * Re: Pulling Rotor Tourige 09/04/06 10:32 PM

Extra information
0 registered and 10 anonymous users are browsing this forum.

Moderator:  Lance Kinley, GTO Pete, Ray 

You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled

Thread views: 2070

Jump to

Contact Us

UBB.threads™ 6.2.3

Generated in 0.017 seconds in which 0.013 seconds were spent on a total of 14 queries. Zlib compression enabled.

Copyright 1999-2005 Lance Kinley

CEG and are not affiliated with nor endorsed by Ford Motor Company