Re: Subframe connectors GB in full effizzect!
#1124161 - 12/13/05 05:56 PM
I didn't want to resurrect the interest thread, so I thought that I would ask here. If this isn't the appropriate spot for this post, let me know. Any chance that these could be handrel bent instead of cut/welded? Reason I ask is due to weld integrity considering full weld penetration in a setup like this is hard to confirm, much less assure AND the point of the weld is approximately where the car naturally flexes, thus applying flex stress on the welds. If this is possible, count me in for 2 sets. If not, I MIGHT be in for a single set. Please let me know. Thanks!