Contour Enthusiasts Group CEG

General >> Troubleshooting

sylin
CEG'er

Reged: 06/12/00
Posts: 56
Loc: Mississauga, Ontario, Canada
The dash lighting went out and I fixed it this way
#1310795 - 09/01/06 04:34 PM

My instrument panel illumination all of a sudden went out and it turned out to be the dimmer control rheostat has gone. Pulled the rheostat and found the ceramic base that the sliding contact sweeps across on had cracked into several pieces, probably from the heat it generates and cycling over time, and some of the piece broke off to nowhere to find. Called the dealler and they wanted CAD$120 plus tax for it . So I decided to go cheap. Instead of simply shorting it out and making the illumination too bright (to me) I spliced in a 12V 35W halogen bulb, that is commonly used on desk lamps and work lamps, in place of the rheostat, after trying with 20W and 50W bulbs for different brightness of illumination. The bulb would glow a little bit and produce some heat during operation but hardly anything to worry about. The rheostat, now a dummy, is put back in only to fill the holes on the panel piece.

Just thought this may help. If you are to try, leave the wire in black alone and splice into the other two wires.

If you'd like to use a resistor instead of a bulb, use a 10W/2.2 ohm or 10W/2.7 ohm for a good result.

--------------------
1997 Contour Sport Duratec MTX
2000 Olds Intrigue GLS Sterling Edition


Post Extras Print Post Remind Me! Notify Moderator

Entire thread
Subject Posted by Posted on
* The dash lighting went out and I fixed it this way sylin 09/01/06 04:34 PM
. * Re: The dash lighting went out and I fixed it this way Tony2005 09/02/06 02:09 AM
. * Re: The dash lighting went out and I fixed it this way Bugzuki 09/01/06 09:40 PM
. * Re: The dash lighting went out and I fixed it this way sylin 09/05/06 05:01 PM

Extra information
0 registered and 23 anonymous users are browsing this forum.

Moderator:  horseydug, Ray 



Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled

Thread views: 2240

Jump to

Contact Us Contour.org

*
UBB.threads™ 6.2.3

Generated in 0.075 seconds in which 0.07 seconds were spent on a total of 14 queries. Zlib compression enabled.

Copyright 1999-2005 Lance Kinley

CEG and contour.org are not affiliated with nor endorsed by Ford Motor Company