Contour Enthusiasts Group CEG

Modifications >> Duratec Maintenance

Pages: 1
Tourige
Hard-core CEG'er

Reged: 05/25/04
Posts: 3637
Loc: Calgary, Alberta, Canada
Pulling Rotor
#1312198 - 09/04/06 08:15 PM

Well it seems my rotor is going to be a huge PITA to get off. I went ahead and got a gear puller that will probably wourk with the rotors (it fits up and everything) its 3 teird and im HOPING it dosent warp it at all.

Now i need to know if its safe to put the middle part (the one tong that works the opposite way) pushing into the axle.. where the axle nut usually is. Can i put any pressure on that, or is it bad for the axle??



--------------------
99 TRed Contour SVT # 1853 out of 2760
230.2 WHP @ 6500
237.0 WTR @ 2250

Originally posted by MxRacer:
Originally posted by RawBurt:
I'll be keeping it to myself, until the time comes. It'll be hard to find.




much like your weiner.




Post Extras: Print Post Remind Me! Notify Moderator
Tourige
Hard-core CEG'er

Reged: 05/25/04
Posts: 3637
Loc: Calgary, Alberta, Canada
Re: Pulling Rotor new
#1312247 (Re: Tourige) 09/04/06 10:32 PM

nm, got it.

--------------------
99 TRed Contour SVT # 1853 out of 2760
230.2 WHP @ 6500
237.0 WTR @ 2250

Originally posted by MxRacer:
Originally posted by RawBurt:
I'll be keeping it to myself, until the time comes. It'll be hard to find.




much like your weiner.




Post Extras: Print Post Remind Me! Notify Moderator
Big Jim
Hard-core CEG'er

Reged: 09/03/00
Posts: 4693
Loc: Thousand Oaks, California, USA
Re: Pulling Rotor new
#1312476 (Re: Tourige) 09/05/06 03:38 AM

Make sure that you apply some anti-sieze between the hub and rotor so that it will come apart easier next time.

--------------------
Jim Johnson
98 SVT
03 Escape Limited

Post Extras: Print Post Remind Me! Notify Moderator
Pages: 1


Extra information
0 registered and 12 anonymous users are browsing this forum.

Moderator:  Lance Kinley, GTO Pete, Ray 

Print Thread

Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled

Thread views: 1839

Jump to

Contact Us Contour.org

*
UBB.threads™ 6.2.3

Generated in 0.02 seconds in which 0.014 seconds were spent on a total of 14 queries. Zlib compression enabled.

Copyright 1999-2005 Lance Kinley

CEG and contour.org are not affiliated with nor endorsed by Ford Motor Company