Contour Enthusiasts Group CEG

Modifications >> Forced Induction

Pages: 1 | 2 | (show all)
RTStabler51
Hard-core CEG'er

Reged: 10/13/00
Posts: 6760
Loc: On the short bus
Re: What N2O kit? new
#1310090 (Re: starjammir) 08/31/06 04:31 PM

Originally posted by starjammir:
I do not know a lot about nitrous, but you can use the 24#ers if the 17's are not enough.



SVTs have 19lbers. And if you are running a wet kit, upgrading the injectors is a waste of money.

--------------------
Ryan
Trollin!


Post Extras: Print Post Remind Me! Notify Moderator
Ray
Addicted CEG'er

Reged: 07/10/01
Posts: 7100
Loc: San Antonio/Austin, TX
Re: What N2O kit? new
#1310106 (Re: Auto-X Fil) 08/31/06 05:00 PM

Phil,

On that picture, it was taken in a state of repair.

The injeectors in that picture would actually "pop" in to the holes on the manifold, the two black strips (seen in the picture, underneath the injectors) would then run on TOP of the injector/rail, and the plugs would plug in to the top, just like you said your system does.






--------------------
'99 CSVT - Silver #222/276
In a constant state of blow-off euphoria.
Originally posted by Kremitthefrog:
I like to wear dresses and use binoculars to watch grandmas across the street.




Post Extras: Print Post Remind Me! Notify Moderator
Auto-X Fil
Hard-core CEG'er

Reged: 08/11/03
Posts: 4140
Loc: Pennsylvania
Re: What N2O kit? new
#1310293 (Re: Ray) 08/31/06 09:13 PM

I have side-feed injectors, those are top-feed. They're quite different. The fuel rail is on the "top" of those, the wires are on the side.

--------------------
-Philip Maynard
'95 Contour [71 STS | Track Whore]
'97 Miata [71 ES | Boulevard Pimp]
2006 autocross results

Post Extras: Print Post Remind Me! Notify Moderator
Pages: 1 | 2 | (show all)


Extra information
0 registered and 4 anonymous users are browsing this forum.

Moderator:   

Print Thread

Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled

Thread views: 3224

Jump to

Contact Us Contour.org

*
UBB.threads™ 6.2.3

Generated in 0.036 seconds in which 0.03 seconds were spent on a total of 14 queries. Zlib compression enabled.

Copyright 1999-2005 Lance Kinley

CEG and contour.org are not affiliated with nor endorsed by Ford Motor Company