Contour Enthusiasts Group CEG

General >> Troubleshooting

Pages: 1
michel
Newbie

Reged: 12/22/04
Posts: 2
Loc: Montreal, Canada
Best way to put the knuckle on the drive axle
#1309185 - 08/30/06 08:28 AM

Hi everebody,

I changed my right wheel bearing today and press it with the right tool and the hub too.

My problem know, I want to know the best way to put the end of the transaxle throught the hud without damaging the bearing or the transaxle. i can use a hammer but I don't it's a good ides.

Let me know how I can do that.

Thanks
Mike

Post Extras: Print Post Remind Me! Notify Moderator
BrApple
Hard-core CEG'er

Reged: 12/23/01
Posts: 6910
Loc: Enfield, CT
Re: Best way to put the knuckle on the drive axle new
#1309213 (Re: michel) 08/30/06 12:28 PM

well there should be a tool out there for that, maybe check autozone or some other place for a rental tool ...


my father made a plate that bolts to the wheel studs and allows for a bar and threaded rod that has a coupler that mates to the axle and then you can pull the axle into the bearing ...

--------------------
- 95 Mystique LS - Zetec/5spd
- 99 Contour SeVT Sport - Duratec/5spd

Official NE-CEG Contour/Mustang Family


Post Extras: Print Post Remind Me! Notify Moderator
Pages: 1


Extra information
0 registered and 19 anonymous users are browsing this forum.

Moderator:  horseydug, Ray 

Print Thread

Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled

Thread views: 421

Jump to

Contact Us Contour.org

*
UBB.threads™ 6.2.3

Generated in 0.087 seconds in which 0.081 seconds were spent on a total of 14 queries. Zlib compression enabled.

Copyright 1999-2005 Lance Kinley

CEG and contour.org are not affiliated with nor endorsed by Ford Motor Company