Pole120
(Hard-core CEG\'er)
12/19/05 02:11 PM
Re: P.R.T. Poly Roll Resistors

Originally posted by darpinian:
I have a couple of questions..

1) why only MTX?




I can do the front for either transmition as they're the same. I only have a jig to do a solid poly rear for the MTX, the ATX mount is a bit different, however i could fill it like i do the fronts.


Originally posted by darpinian:
2) is it possible to fill the ATX mounts?




See above.

Originally posted by darpinian:
MY understanding (very limited) is that the mounts connect the engine/transmission to the subframe of the car, right? so therefore filling it with a hard substance (the polyurethane) cause the stiffness that cause the NVH but at the same time prevent or dramatically reduces the wheelhop associated with the engine itself moving?


~darp~






Correct.



Contact Us Contour.org

*
UBB.threads™ 6.2.3

Generated in 0.006 seconds in which 0 seconds were spent on a total of 4 queries. Zlib compression enabled.

Copyright 1999-2005 Lance Kinley

CEG and contour.org are not affiliated with nor endorsed by Ford Motor Company