hi all just asking if anyone knows how difficult it is to cut another hole in the bumper for twin exit exhaust like on the st200 . i have a mondeo st24 and iam wanting to do this .or dose anyone know were to get a second hand st200 rear bumper from.thanks
-
Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.
You can register to join the community.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
mondeo st200 rear bumper
- Thread starter mondyst24
- Start date
Smalls
Addicted CEG'er
im pretty sure you're on the wrong forum. very few mondy owners are regulars on here
Rara
Hard-core CEG'er
Cutting the hole is easy, making it look right is a totally different story. If you are asking the question, then its probably a better route to buy an ST200 bumper and sell the ST24 one. Though to be honest, its probably going to be very difficult to find a second hand ST200 bumper.
saintz
CEG'er
Cutting the hole is easy, making it look right is a totally different story. If you are asking the question, then its probably a better route to buy an ST200 bumper and sell the ST24 one. Though to be honest, its probably going to be very difficult to find a second hand ST200 bumper.
Hi,
I am an ST24 owner, Rara is right you would do better getting a 200 bumper then selling your ST24 one, they sell quite well in the UK as non ST owners go mad for them.
Try these forums in the UK for more advice
www.saintzonline.com
www.fordmondeoownersclub.co.uk
www.fordstownersclub.co.uk
hope this helps.