Rabbits ate the wiring above the pigtail connector on the O2 sensor located next to the lower driver-side engine mount/roll resistor.
I am planning on replacing the wire and using the existing pigtail connector, however the rabbits chewed all the way through and I have no way of knowing which color belongs in each of the four sockets in the Bosch O2 sensor:
Can anyone tell me which wire goes where, or perhaps take a photo of yours?
Much appreciated!
I am planning on replacing the wire and using the existing pigtail connector, however the rabbits chewed all the way through and I have no way of knowing which color belongs in each of the four sockets in the Bosch O2 sensor:
Can anyone tell me which wire goes where, or perhaps take a photo of yours?
Much appreciated!