+ Reply to Thread
Results 1 to 10 of 10

Thread: Remote start Contour

  1. Default Remote start Contour

    I bought a Python 881xp remote start security system for my 2000 Contour. It has like 25 wires and they go everywhere. I was wondering if anyone else has put one of these or something similar in to their car and what i should watch out for...

  2. #2
    Join Date
    Aug 2002
    Location
    the 248
    Posts
    11,141

    Default

    sounds like you need to pay someone

  3. #3
    Join Date
    Jun 2005
    Location
    Virginia, USA
    Posts
    11,070

    Default

    Remote start FTL.

    Read this thread.
    http://www.contour.org/ceg-vb/showthread.php?t=6440
    "Always do the cheap and easy ones first."

    "Without fear or favor." 1996 V6 ATX 144K miles

    "Entiendo un poco espaņol"

  4. #4
    Join Date
    Jul 2004
    Location
    Minneapolis, MN
    Posts
    512

    Default

    Depending on where you go for install, and also dependent on if your vehicle is a Manual or Auto transmission the install price will vary 150- 250. You will need a PATS bypass module 20 bucks, and need to have a second key programmed 50-100 bucks for your car if you dont have one, clutch bypass is necessary (even though its only a relay) 25 bucks, In the end, on a cold day, when you dont wanna run outside, its kinda nice, but also, as you may have read, if your battery aint up to par for WHATEVER reason, youll be an unhappy camper. I do have a remote start on mine, Im in Minnesota and it gets cold up here once in while, but be prepared for that ONE day out of the year, that your car may not start. my 2 pennies.

    But just for fun here you go....2000 Ford Contour Security Information
    Constant 12V+ Red Ignition Switch Harness
    Starter Gray/White Ignition Switch Harness
    Ignition Green Ignition Switch Harness (heater)
    Accessory Orange or Red/Blue Ignition Switch Harness
    Tach Brown/Green or Brown/Blue Coil Pack, Use 2 Cylinder Setting
    Neutral Safety Wire Black/Yellow Switch on Driver's Transmission
    Brake Switch Orange/Yellow or Orange/Black Brake Switch
    Trunk Release Orange/Green (+) Switch or Keyless Module behind Glove Compartment
    Trunk Pin Black/Red (-) Keyless Module behind Glove Compartment
    Parking Lights Red/Blue (+) And Red/Yellow at Light Switch Harness
    Head Lamp Orange/Yellow (+) Light Switch
    Factory Disarm Yellow/Purple (-) Driver's Kick Panel
    Door Trigger Blue/White (-) Courtesy Light under Dash
    Door Lock White/Green (+) Driver's Kick Panel
    Door Unlock Yellow/Green (+) Driver's Kick Panel
    Driver's Lock White/Green Left Kick Panel
    Driver's Unlock Yellow/Purple Left Kick Panel
    Passenger Unlock Yellow/Green Left Kick Panel
    Horn Wire Red/Orange (-) 3 Pin Black Connector at Steering Column
    Windows Up LF=Yellow, RF=Yellow/Purple, LR=Yellow/Purple, RR=Yellow
    Windows Down LF=Yellow/Green, RF=White/Purple, LR=White/Blue, RR=White
    Last edited by fordsvt98; 01-22-2007 at 09:52 PM.
    1998 Contour Svt Born 5/12/97 #897 of 6535 or 2487
    (depends how you look at it)

  5. #5
    Join Date
    Jun 2004
    Location
    Kitchener, ON Canada
    Posts
    1,996

    Default

    Quote Originally Posted by Tony2005 View Post
    Remote start FTL.

    Read this thread.
    http://www.contour.org/ceg-vb/showthread.php?t=6440
    Yeah, must say mine crapped out on me as well. Not sure whats wrong with it, but to its credit the alarm feature was the issue. Remote Starter was fine for a couple more months and than only started to have problems when it was damp out. Now it does not respond at all. I was going to have someone look at it when my income tax comes in, but now that I am in an apartment building and the lot is on the other side, I am out of range. So meh, as for the problem of installing it, get someone to do it. Get some kind of warranty that if it craps out later, they will fix it or repair it for free.
    95 Mystique 2L Auto
    98 SE Contour Auto
    98 Taurus Vulcan Auto

  6. Default

    I dont know where i can find someone to put it in for me, i bought it off of e-bay for $300 under the normal price (which i was amazed by)... I know it would take me all day and night and id still do it wrong but i dont know who i can have do it...

  7. #7
    Join Date
    Jun 2004
    Location
    Kitchener, ON Canada
    Posts
    1,996

    Default

    Is there no local car audio place that has experience with them? If your really stuck you could find a Best Buy, but be forewarned, you might come out unhappy.
    95 Mystique 2L Auto
    98 SE Contour Auto
    98 Taurus Vulcan Auto

  8. #8
    Join Date
    Jul 2004
    Location
    Minneapolis, MN
    Posts
    512

    Default

    My 2 cents is if you cant do it, dont start the job. If you take it somewhere half-arsed, the Install place is gonna be like, "we're gonna remove all your wires you did cause we dont want a liability on our hands" plain and simple, save up the 200 bucks and bring it in to a specialty shop. Theres gotta be one in your nieborhood somewhere. Best Buy Meh, its all the same wires if they have a install bay, they've done plenty of installs im sure, but it would all depend on what installer you get that day. Try to find a place that deals with your particular alarm, DEI is it? Python you said....well theyre pretty much everywhere and im sure where ever you go, will give you at least 6 months warranty. My advice is pretty much useless but I like typing. lol01
    1998 Contour Svt Born 5/12/97 #897 of 6535 or 2487
    (depends how you look at it)

  9. #9
    Join Date
    Oct 2006
    Location
    Chisago City, MN
    Posts
    1,707

    Default

    We have had all of our remote starters instaled for our cars (95 f150, 97 LeSabre, 92 K150, 99 Tahoe) at Ultimate Electrnoics without a single problem. I will most likly be taking my car there if I get a system they sell. If I go Compustar, Mach1 Car Audio will be my choice.
    2000 Black/Tan Contour SVT 3L
    131 of 2150 - WeaponR Y-Pipe
    MSDS X-Treme Coated Headers
    18" BSA 259's - Torsen T2 -
    K&N RU3530 - 8lb Fidanza
    Spec Stage 3+ - Ford Racing Wires
    182 FWHP 187 FWTQ Without a Tune

  10. #10
    Join Date
    Jul 2004
    Location
    Minneapolis, MN
    Posts
    512

    Default

    Mach1 is where I got my Compustar installed at. Golden Valley one. Super cool people there.
    1998 Contour Svt Born 5/12/97 #897 of 6535 or 2487
    (depends how you look at it)

+ Reply to Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts