ECU re-mapping

[mattyninegrand]

Hi all

Well it's been a long time and hope you have all had a happy holiday.

Since I was last on here I had to change a head gasket on my ST24 - what a nightmare!!!!!! but all done now and wasn't running quite right so bought an ODBII cable and plugged my laptop into it and hooked it upto the diagnostic port on the ECU, there was a couple of faults showing which had appeared whilst re-building so cleared the faults from the memory and the car is like a new car, drives great!!!!!!!!!

I want to take this ODBII connection to the next step and re-program the ECU, now I know there is a handheld device from superchips that plugs into the ODBII port on the car and re-maps the ecu and gives an extra 15bhp approx.

I am after the software or a similar software that I can re-program the ecu to give me these extra horses.

Does anyone know of any such software or any other way I can up the bhp with my laptop connected?

Any help much appreciated.

M9G

[beyondloadedSE]

I would suggest the "PCM Tuning" branch that we have.

[mattyninegrand]

I would suggest the "PCM Tuning" branch that we have.

Thanks, have already checked that out but not really what I am after, I have plenty of diagnostic software but non that re-map and provide the flash for the chip.

Regards

M9G

[yamaha racer 686]

i think what your looking for is the SCT XCAL2 w/ the Pro racer package. from what im told you can change almost everything you want.

[mattyninegrand]

i think what your looking for is the SCT XCAL2 w/ the Pro racer package. from what im told you can change almost everything you want.

Oh right!! thanks i'll have a look

I have been trying to source an SVT UIM, LIM and throttle body that can be shipped over here but as yet no luck.

Regards

M9G

[DemonSVT]

You are in the wrong forum. Check out http://www.fordmondeo.org/ (MEG)

Our (USDM) SCT X-cal unit will not work with your European Unicode PCM. You want to look at the Superchips programmer made for unicode Fords like you mentioned. Our US software is not compatible.

[mattyninegrand]

You are in the wrong forum. Check out http://www.fordmondeo.org/ (MEG)

Our (USDM) SCT X-cal unit will not work with your European Unicode PCM. You want to look at the Superchips programmer made for unicode Fords like you mentioned. Our US software is not compatible.

Hi

Yep i'm a member of MEG and not really after a superchips programmer as it is a preset handheld tool. What I am after is just some software that i can load onto my laptop and make the alterations myself or flash the chip.

The software I am after must be out there somewhere.

Regards

M9G