Hawkrunner03,
Here is what happened.
My car was detailed last week. This man detailed it & cleaned the engin is an experienced detail man as that is all he does during the week for a major car dealer. When I picked it up my started fine & I drove it about 15 mi then it stalled out when I had to brake & slow down for a traffic light.
My regular mechanic he cannot get it to diagnose on his scope because it dies when he tries to scope it. Kind of funny because I found I could drive it for a while before it would stall again as I slowed down then if I let it rest for about 15 min it would start again.
The mechanic says the wiring harness is bad. He showed me wires going into the Throttle Position Sensor & the Idle Control Arm that are completely bare & touching each other. The harness alone is 1400. He said this type of thing happens so little that he couldn't give me a labor estimate, i. e. there is no book on it.
I know the harnesses were bad on this year but I bougtht the care with 77,000 mi on it & have driven 60,000 mi since then & never had an electrical problem.
What advice can you give? Should I try having them wrap the wires that we can see are exposed & see how the car does, buy a harness from a junk yard--do other year harneeses fit a 95, junk the car?