• Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.

    You can register to join the community.

Keyless entry remote programming

BrApple

No Life But CEG
Moderator
Joined
Dec 23, 2001
Messages
21,731
Location
Gales Ferry, CT
(again taken from them main site)

For the Keyless Entry Transmitter:

Up to 4 transmitters can be programmed.
  • Gather up ALL of the units you want to use.
  • Find a paper clip, open it up and reform it into a U shape.
  • Empty your glove box, deflect the sides in, and drop it all the way down toward the floor.
  • Look at the harness behind the glove box. It runs along the cross brace. Look for a white, two pin, unterminated connector - it may be taped into the harness. This is the programming connector. In the picture below this is the white connector with the yellow incert.
    DSC00878.JPG
  • Turn the ignition ON so the dash lights come on.
  • Take your paper clip and insert it in to the two pin connector.
  • The horn will chirp to confirm that you are in programming mode.
  • Press any button on Transmitter #1.
  • Horn will chirp to confirm programming.
  • Press any button on Transmitter #2.
  • Horn will chirp to confirm programming.
  • Repeat for Transmitter #3 and #4 if applicable.
  • Remove paper clip from connector.
  • Turn igniton OFF, horn will chirp to confirm exit from programming mode.
 
Back
Top