well, my CEL was on and got the codes pulled....326 was the lucky draw. I then went on to check the DPFE sensor by:
1. Disconnecting the pressure hoses
2. connected a vacum pump to the ref port
3. with key on signal voltage was at .10 volts (spec calls for .20-.70)
5. I then applyed 9ish mm HG and it was around the specifed 4 volts
6. I quickly relesed pressure and it was a bit slow to respond
7. checked the electrical connections for any obvious dammage, they were fine
...though this procees I have detremined that the sensor is bad, but I don't want to spend $50 on a new sensor so I am trying to find workarounds this is a ll I got:
http://www.focushacks.com/printable.php?modid=80
I have a 1995 Contour Gl 2.0L, with 105,000miles
1. Disconnecting the pressure hoses
2. connected a vacum pump to the ref port
3. with key on signal voltage was at .10 volts (spec calls for .20-.70)
5. I then applyed 9ish mm HG and it was around the specifed 4 volts
6. I quickly relesed pressure and it was a bit slow to respond
7. checked the electrical connections for any obvious dammage, they were fine
...though this procees I have detremined that the sensor is bad, but I don't want to spend $50 on a new sensor so I am trying to find workarounds this is a ll I got:
http://www.focushacks.com/printable.php?modid=80
I have a 1995 Contour Gl 2.0L, with 105,000miles
Last edited: