SableSal
New CEG'er
Well, I'm installing the crank UDP. I can't seem to get this crank pulley off. It's on a 3L Duratec. I've PB Blasted it, and am using a impact on it.
Couple of questions for you guys, I am suppose to turn clock-wise in order to loosen, right? That's what the bolt head states.
Also, the starter pump solution seems to not work, since the crank turns clock-wise. If I were to jam it, it would TIGHTEN rather then LOOSEN??
Am I correct? Please lemme know
Thanks,
Sal
Couple of questions for you guys, I am suppose to turn clock-wise in order to loosen, right? That's what the bolt head states.
Also, the starter pump solution seems to not work, since the crank turns clock-wise. If I were to jam it, it would TIGHTEN rather then LOOSEN??
Am I correct? Please lemme know
Thanks,
Sal