1. Announcement:
    Forum Posting Rules Updated 3.16.08
    Rara (Admeanistrator)
    09-25-2006
    Views:
    33,931
+ Post New Thread
Page 1 of 2
1 2 LastLast
Threads 1 to 20 of 36

Forum: M&M HOWTO

Modifications and Maintenance HOWTO documents

  1. Post Sticky Thread Sticky: M&M Suggestion Box

    This is the area to provide suggestions for How-tos and ways to improve the following forums: - General Mods - Transaxle - Suspension - Brakes -...

    Started by GTO Pete, 08-27-2006 06:25 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 6,403
    02-24-2009 09:39 AM Go to last post
  2. Sticky Thread Sticky: How-To archives:

    There is a thread on archived how-tos. Please read this thread if you are looking for a specific how-to. ...

    Started by Ray, 11-10-2008 06:30 PM
    • Replies: 0
    • Views: 1,826
    11-10-2008 06:30 PM Go to last post
  3. Post Sticky Thread Sticky: M&M How-to links:

    This is a list of modification and maintenance procedures that are NOT explicitly for either the Zetec, or the Duratec. Please note: There MAY BE...

    Started by Ray, 10-04-2006 11:32 PM
    • Replies: 0
    • Views: 4,777
    10-04-2006 11:32 PM Go to last post
  1. The ONLY trunk lid strut removal How-To! Video inside.

    Don't listen to what anyone else tells you, this is the easiest way to do this. Repeat the process for the other side and do the reverse process to...

    Started by blu_fuz, 01-03-2010 02:00 PM
    • Replies: 0
    • Views: 549
    01-03-2010 02:00 PM Go to last post
  2. 1998-2000 Contour/Mystique Remote Start / Keyless Entry Install

    I wrote this how-to based on the install of a DEI remote start w/ keyless entry module in a 1998 Contour, automatic transmission. It is important to...

    Started by ZX2Fast, 12-25-2009 07:22 AM
    • Replies: 3
    • Views: 712
    12-30-2009 09:27 PM Go to last post
  3. PATs Key Programming

    As taken from the main site with some modifications. The below instructions are for early 98 cars. To program a new key: · Buy a...

    Started by BrApple, 07-29-2008 08:15 AM
    • Replies: 1
    • Views: 1,014
    12-30-2009 03:13 PM Go to last post
  4. Wheel Bearing Replacement - part two

    Please add this post after the first part. Remove the knuckle by tapping it off with a hammer (does not have to be real hard)...

    Started by Bugzuki, 11-03-2009 01:32 AM
    • Replies: 4
    • Views: 1,113
    11-25-2009 08:16 PM Go to last post
  5. Wheel Bearing Replacement - with pics

    Here is what I did to replace the wheel bearings: Remove the Wheel Remove the axle nut (I got some hired help for this part) Use a 1-1/4...

    Started by Bugzuki, 11-03-2009 01:11 AM
    • Replies: 0
    • Views: 471
    11-03-2009 01:11 AM Go to last post
  6. Post (ReUp) HowTo: Fog Light MOD w/ Remote Entry

    *** First and foremost; I did not create this mod or the original HowTo. I am simply adding photos to it and a bit more detail to make this...

    Started by Blast47, 10-21-2009 07:06 PM
    • Replies: 0
    • Views: 621
    10-21-2009 07:06 PM Go to last post
  7. Alternator Removal Overview (How-To)

    Here is a brief explanation through the use of photos of the removal of my alternator. Would suggest referencing Ray's PDF file how-to as well, but...

    Started by CSVT#49, 07-15-2009 10:18 PM
    • Replies: 0
    • Views: 1,148
    07-15-2009 10:18 PM Go to last post
  8. how to add hightower expressopen AND close

    hightower's expressopen is one relay that basically works off the "back" arrow on the moonroof switch so that it will autoclose when the vent is up...

    Started by hmouta, 04-25-2009 10:02 PM
    • Replies: 5
    • Views: 1,615
    06-29-2009 02:08 PM Go to last post
  9. possible altenator FAQ

    So your battery light is on, well read this: First thing you do is test your battery. This is how Start by charging the battery well. Then...

    Started by stocksvtcontour, 11-13-2006 04:19 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 7,384
    06-04-2009 11:43 PM Go to last post
  10. how to replace fuel line

    This how-to might be useless for the majority but it's possible that someone might make a rookie mistake like i did.:shrug: I made this how to...

    Started by montrese04, 04-02-2009 04:20 PM
    • Replies: 0
    • Views: 488
    04-02-2009 04:20 PM Go to last post
  11. How to: Cowl Screen Area (To include...)

    Wiper Arm removal, Cowl Screen removal and Fresh Air (Cabin) filter replacement. This is valid for all year Contour and Mystiques. The hood...

    Started by 69Boss302, 03-20-2007 02:07 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 4,318
    02-16-2009 08:10 PM Go to last post
  12. How to: Blower Motor Resistor Replacement (Fan only works on high!)

    Recently, the heat/air fan on my sister's '99 Zetec ATX started only working on high, no matter where the fan speed knob was set. Instead of paying...

    Started by PurpleMystique, 02-16-2009 08:07 PM
    • Replies: 0
    • Views: 609
    02-16-2009 08:07 PM Go to last post
  13. Billet Mustang Fuel Door w/o body damage

    Instructions for installing the Mustang aluminum fuel door without body damage and retaining fuel door assembly 1. Open the fuel door 2. Remove the...

    Started by guzzi svt, 01-06-2009 04:19 PM
    • Replies: 0
    • Views: 1,132
    01-06-2009 04:19 PM Go to last post
  14. Hood lifts

    I got mine at Auto Zone for $20 each. They go by the brand name Mighty Lift part # D95247. The cartridge is about 9 inches long with ball ends. The...

    Started by guzzi svt, 01-06-2009 04:14 PM
    • Replies: 0
    • Views: 728
    01-06-2009 04:14 PM Go to last post
  15. Subframe bolt extraction

    Perhaps you are replacing your control arms. Perhaps you are pulling your engine following the procedure recommended by Ford. Regardless, you're...

    Started by SoopaCooga, 08-10-2008 11:37 PM
    • Replies: 5
    • Views: 1,358
    12-17-2008 12:56 PM Go to last post
  16. Fog Light Mod Version 2.0

    Fog Light Mod Version 2.0 There is already a current thread on this... http://contour.org/ceg-vb/showthread.php?t=15637 Really haven't got...

    Started by CSVT_2004, 08-02-2007 04:30 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 39
    • Views: 6,886
    11-09-2008 06:15 PM Go to last post
  17. How to add auto down to passenger door

    Auto down for front passenger side door (revised 8/07) 11/11/06 For 95- 00 Tours, & Stiques..... I just...

    Started by Aussie Ford, 09-01-2007 02:49 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 34
    • Views: 5,979
    11-03-2008 06:08 PM Go to last post
  18. How-To, ATF Change

    Hey guys, I know there's one on the old forums, but it's hard to find, and has a few holes in it. So, here we go. (Pics soon) NOTE For 1995-96...

    Started by cobrawannabe, 09-08-2008 06:08 PM
    • Replies: 4
    • Views: 1,582
    09-28-2008 05:06 PM Go to last post
  19. Checking the Airbag Sensor Mounting

    Tools required 10mm combination wrench 1/4" drive tools -Ratchet -6" extension -3" extension -8mm socket Pick-up magnet (optional) Small...

    Started by DDV, 05-02-2008 10:32 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 2,286
    09-27-2008 11:38 PM Go to last post
  20. Keyless entry remote programming

    (again taken from them main site) For the Keyless Entry Transmitter: Up to 4 transmitters can be programmed. Gather up ALL of the units...

    Started by BrApple, 07-29-2008 08:18 AM
    • Replies: 0
    • Views: 1,349
    07-29-2008 08:18 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts