HOWTO documents relating to the Zetec 4-cylinder
There is a thread on the archived How-To files of CEG.. please read this if you are looking for a specific How-to. ...
Original thread can be found here: http://www.contour.org/ceg-vb/showthread.php?t=1600
SleeperZ Intake How-To; Parts Needed; 2.75" to 2.75" 90 degree silicone elbow 2.75" to 3.00" 45 degree silicone elbow atleast 16" of 2.75"...
I just found by mistake everything there is to know about the Zetec engine.Testing sensors , timing and more. It's in Portuguese but you can skip...
IMPORTANT The ZX2 Zetec is a non-interference engine. This means the valves are not capable of touching the pistons at any time. If your belt breaks,...
(figured this was in the duractec section, but it works for zetecs just as well) How-to # 2! This is for the pre-98 Tour owners like me who wanted...
(figured this was in the duractec section, but it works for zetecs just as well) Ok, so I've finally been a member for over a month, so I can...
"originally posted by Cris'pus" Thanks Brapple for the hard work, but I thought that being you dealt mainly with pre-98 stuff (tensioner...
Hi, I am in a bit of a Contique crisis, I need a car quite quick, since I am gonna move next week, and still don’t have a car, and was too busy...
My wife's '99 Contour popped a radiator hose, and shows all the signs of a warped/cracked head. I came across a zetec engine that was such a good...
Here are the instructions for timing belt service from the Ford Service Manual for 1995 From the imformation I have read here the timing belt...
Ok, so I bought this air/fuel ratio guage for the ole zetec and I'm looking at the instructions and a few questions are popping into my head. Where...
Well, What I would like to know is if anyone knows a way of figuring a 1/4 mile time by whp? of a contour/mystique? also, Does any one...
Hi guys I am currently at 580 miles and wondering what is the best way to break in an engine. I have eagle rods and je pistons & rings. My...
i pulled it out and kicked the gass and i hit 60 in about 8 seconds, so i'm guessing the cat is the problem... so how do i go about replacing that...
1) Disconnect negative terminal battery (note you will lose all CEL codes stored in the PCM memory) 2) Disconnect Upper O2 sensor connector ...
Author: Nishal Patel Applicable to: All vehicles with Zetec engine (Downloadable text file attached) Disconnect the Battery (Since you may...
Any HOW TO you want to contribute, post it!:cool:
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
