Enlist the help of others with troubleshooting your vehicle
Welcome to the Contour Enthusiast's Group, often abbreviated as the CEG. You've stumbled upon this site, either by accident or from searching,...
There have been an increasing number of posts in the troubleshooting forum asking about removal procedures, and specific instructions on parts. ...
I know it's been awhile since I've been on here... but a problem has recently reared its ugly head and I need some help to diagnose it :help: ...
Where to begin? Car stalls under load only, Idles fine. Replaced camshaft sensor, maf sensor fuel filter checked compression (150 at each), coolent...
My car has been making a whirring noise that changes with speed. It is not a continuous whir but a on off noise "whir whir". It happens in gear in...
anytime i press the gas or let off the whole car violently jerks forward and back like i'm dumping the clutch. i have to ease on the gas very gently...
I'm hunting a CEL light in my sister's car that's pointing me to the EGR (I don't remember the code offhand). I replaced the EGR, and in the process...
Hello all. I've got a '98 2.5 w/ ~130k. For several months now, the ATX has been shifting poorly, both up and down, but most notably up. This...
Okay, I have been using the search funtion for about two hours and I have not yet found the info I need. Soo, First of all the fan setting only...
I replaced my front outer tie rod ends and wheel bearings in September 2009 and had an alignment done shortly thereafter to put everything back into...
I have no idea how this happened. There is a little plastic elbow that connects a hose to the thermostat housing. This broke. Has this happened to...
I pulled my codes and got "intake manifold runner control stuck open" Now I'm not sure what this means?...does it effect the overall performance...
My tour is having a problem with engine codes 1151 (Lack of switches-bank 2 sensor 1, ECM could not adjust fuel trim because of a lean or rich fuel...
A Heated Exhaust Oxygen (HO2S) sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when...
My 98 csvt needs fuel. The pump wasn't priming so I replaced the pump to then find out that the connector to the fuel pump has no power. The relay...
Has anyone succesfully replaced the entire hub assembly without removing the compressor from the car? Right now I have everything off of the...
:confused: 96 Contour 57K miles. 2.0 Idles fine in park and neutral. Super rough idle in drive and reverse. Otherwise great car for my son. keep...
I have some knocking coming from the AC compresser area. At idle and rpm dependent. What part do you think it is and be able to replace? I have...
So i have a 2000 svt i have had it for almost a year, and i was driving home today and all of the sudden my clutch pedal is at the floor with no...
my camshaft and crankshaft sensor burned up and now can not get the car to fire wat is it
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
