Stuart-Grant
CEG'er
You might remember my IC thread from a while back. Sorry to say I'll never get these in production, so only three sets exist, one is on Beans' car, another on Jaged's race Cougar, so the final set is up for grabs, never used.
The arms are made from 304 Stainless steel, the tubular section is .12" thick square tubing, the bearing block and fork are CNC'd from billet. All welds were undercut and back purged for a near perfect weld from the root up, then the welds were ground flush. The entire arm and the spacers were passivated to prevent oxidation of the arm for the foreseeable future. Buyer also receives specifications for bearings and the spacers in case they ever need replaced.
The arm itself is about .125" longer than stock, introducing some negative camber, but not much.
Price is $650 shipped in the US, from SE Michigan.
Checkout my NECO thread for more on the development process.
The arms are made from 304 Stainless steel, the tubular section is .12" thick square tubing, the bearing block and fork are CNC'd from billet. All welds were undercut and back purged for a near perfect weld from the root up, then the welds were ground flush. The entire arm and the spacers were passivated to prevent oxidation of the arm for the foreseeable future. Buyer also receives specifications for bearings and the spacers in case they ever need replaced.
The arm itself is about .125" longer than stock, introducing some negative camber, but not much.
Price is $650 shipped in the US, from SE Michigan.
Checkout my NECO thread for more on the development process.