DumbContourdriver
New CEG'er
So my 1999 contours been dead the past 10 months, it would crank fine but wouldn't fire. its the zetec 2.0L. It started running poorly after I had the timing belt replaced as well as the fuel pump because the day I drove it over the pump cracked, started leaking 1/4 tank every mile 1/2. The belt was replaced shortly before I bought it, and long story short they didn't do it right so it threw a code for retarded timing. Any ideas why it wont fire?This is an early 99 so its return fuel system.So anyway I've replaced these things so far:
*plugs and wires
*coil pack
*maf
*cam sensor and wiring
*fuel pump(again)
*fuel filter
*valve cover gasket
*Air filter
Parts I'm working on:
*crank sensor and wiring(can't get enough clearance to replace it)
*iac(same deal)
*fuel pump control module(can't find it)
*fuel tank pressure sensor(also unable to find)
had code for cam sensor, fuel tank pressure sensor, and retard timing. Fuel pressure is 35-45ibs, and I'm pretty sure I have spark.
*plugs and wires
*coil pack
*maf
*cam sensor and wiring
*fuel pump(again)
*fuel filter
*valve cover gasket
*Air filter
Parts I'm working on:
*crank sensor and wiring(can't get enough clearance to replace it)
*iac(same deal)
*fuel pump control module(can't find it)
*fuel tank pressure sensor(also unable to find)
had code for cam sensor, fuel tank pressure sensor, and retard timing. Fuel pressure is 35-45ibs, and I'm pretty sure I have spark.