View Full Version : got little scratches in clearcoat on paint
97vulcan
07-19-2007, 02:59 PM
Whats the best way to remove tiny circular scratches in the paints clearcoat on the body. My car color is silver. Will a wax, or polish help remove them, or blend them in?? :shrug:
Thanks,
Adam
Linkman
07-19-2007, 03:14 PM
If they are not too widespread, I use Meguiar's Scratch X. Scratch X and some elbow grease with a clean applicator pad, and microfiber to buff it off, will work wonders.
If it's all over the car, you'll really want to use a tool (PC) and some compound. I don't have experience with that, other than experimenting with a PC and some 3M polishing compound.
97vulcan
07-19-2007, 04:50 PM
thanks for the help. my friend saw the scratches and said they were in the paint. Is there any hope? I'll try to take a picture of what I am talking about.
Thanks,
Adam
97vulcan
07-19-2007, 11:46 PM
If the scratches did make it past the clear coat, but not too far, and definatly not to the primer, would Scratch X help make them less obvious?? :help:
Thanks,
Adam
SVTJON87
07-20-2007, 01:51 AM
If the scratches did make it past the clear coat, but not too far, and definatly not to the primer, would Scratch X help make them less obvious?? :help:
Thanks,
Adam
probably no. sorry
97vulcan
07-20-2007, 12:22 PM
Will waxing and polishing that area make it less obvious to the eye at least??
Adam
LauraSVT
07-20-2007, 03:15 PM
If they're minor, you should be able to reduce or eradicate their appearance by waxing and polishing. Using a wheel or orbital buffer will provide the best results. Using a wheel is a special skill. Ham-fisted efforts can burn the paint. The orbital is a much safer bet, and should make an improvement.
Dr. Cross
07-20-2007, 03:22 PM
Meguiar's claims that NXT will to help reduce the appearance of fine swirls. This would only be a temporary fix as the fillers would eventually wear out. A good polish w/ a machine is the only permanent solution (aside from a repaint, of course).
97vulcan
07-20-2007, 04:14 PM
Thanks guys for all your help! I was planning on using Meguiars Diamond Cut stuff with a OB. Is the diamond stuff any good?
Thanks again!
Adam
vBulletin® v3.7.1, Copyright ©2000-2009, Jelsoft Enterprises Ltd.