PDA

View Full Version : Motor and Maintenance How-To



  1. Welcome to Zetec HOW TO
  2. Suggestion Box
  3. Motor and Maintenance - Table of Contents
  4. SleeperZ Intake
  5. pre98 timing belt faq
  6. post 98 timing belt faq
  7. throttle position sensor (tps) installation/part numbers
  8. PCV Valve replacement on Zetec 2.0L
  9. Bank 1, Sensor 1 (upstream, firewall) O2 replacement
  10. How-to: Oil change
  11. How-to: Clean MAF (Mass Air Flow sensor)
  12. El Cheapo Duratec Plugged Exhaust Test.
  13. El Cheapo Catalytic Converter Test for the Zetec 2.0 L 4 cylinder
  14. How-to: Hayden #404 Cooler Install for CD4E
  15. A/C Install and Starter
  16. Contour Fuel Pump Replacement
  17. Water Pump
  18. Proper Way To "break" in an engine????
  19. how to figure 1/4 times w/hp #'s
  20. DIY poly fill roll restrictor
  21. found this
  22. 2.5 removal
  23. mil eliminator
  24. Clutch check?
  25. Returnless Fuel Pump Replacement w/Motorcraft PFS289
  26. Where is the production number?
  27. identifying which zetec engine I have
  28. Blank off EGR valve
  29. How-To archives:
  30. How-to Repair IMRC cable
  31. How To: Spark Plugs
  32. Beginners How To: Throttle Hang Fix
  33. How-To Remove Your TPS Sensor
  34. My timing write up
  35. VCT Zetec Timing Belt Replacement.
  36. 65mm Mustang How-To
  37. Zetec Info
  38. Flood's Idiot-Proof How-To's: Fixing Shifter Play
  39. 2.5 diagrams and drawings
  40. How to: Replace Crank Pully (Harmonic Balancer) and/or Timing Cover Seal, Install DMD
  41. Installing a stretch fit belt
  42. Coming soon
  43. Returnless Fuel Pump Replacement
  44. How to make new rear swaybar brackets on subframe.
  45. Starter Replacement How to
  46. DIY: Build a Vacuum Leak Detector Smoke Machine