CEG Forums - CEG Happenings

SZ2010 Itinerary

Pole120

Published on 03-05-2010 06:04 PM

SZ2010 Official dates: May 20-23 There are still ...

SVTOA 2010 Membership Discount for CEGers

WorldTour

Published on 03-01-2010 03:25 PM

If you are planning on joining the SVTOA or renewing an ...

1 Comment

Recent Discussions!

grounds

Thread Starter: 1998contourgl

where are all the ground wires under the hood? where do they run to? i think that is why my car stalls going to put it into drive

Today 02:39 AM by 1998contourgl

Sub Frame Connectors causing exhaust hook rubbing issue!

Thread Starter: Mac

I just got my Sub frame connectors welded on today and as i was leaving the shop, i started to hear something rattling when i would get to certain RPM's

Today 01:39 AM by jaged

Heater Switch

Thread Starter: adamgx03

I have read many posts on this topic but need some reassurance I suppose. My fan switch works on low...if I jiggle it that is, ha. I believe I could

Yesterday 10:55 PM by turboman57

the white stig is.............

Thread Starter: Harrry

Ben Collins http://news.yahoo.com/s/ap/20100901/...itain_top_gear

Yesterday 10:46 PM by JaTo

Sections

Active Forums

Duratec Performance

Engine, induction, exhaust, and electronics modifications for the Duratec V6

Common Interests

Common interests among CEG members -- Cars, computers, careers, etc. For topics not directly Contour/Mystique related. Some topics are not appropriate and will be removed.

General Troubleshooting

Enlist the help of others with troubleshooting your vehicle

Southeast

Florida, Georgia, Tennessee, Carolinas, etc.

Duratec Maintenance

Maintenance questions and discussions regarding vehicles with the Duratec V6 engine.

General Discussions

General Contour, Mystique, and Mondeo discussions

New England

Vermont, Connecticut, Massachusetts, Maine, Rhode Island, New Hampshire.

Forced Induction

Turbos and superchargers for the Duratec V6

Exterior

Aesthetic modifications. Exterior mods for making your car look better.

PCM Tuning

PCM Tuning and calibration